vmware复制虚拟机出现Error:No suitable device found:no device found for connection 'System eth0'
废话不多说,直接给出解决办法:
1、查看硬件地址
[root@master ~]# ifconfig
eth2 Link encap:Ethernet HWaddr 00:0C:29:89:18:58 inet addr:192.168.11.200 Bcast:192.168.11.255 Mask:255.255.255.0 inet6 addr: fe80::20c:29ff:fe89:1858/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:75 errors:0 dropped:0 overruns:0 frame:0 TX packets:62 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:9897 (9.6 KiB) TX bytes:9389 (9.1 KiB) lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:65536 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
硬件地址是:00:0C:29:89:18:58
2、修改硬件地址
[root@master ~]# vi /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE=eth0 BOOTPROTO=static HWADDR=00:0C:29:89:18:58 IPV6INIT=yes NM_CONTROLLED=yes ONBOOT=yes TYPE=Ethernet UUID=a221696a-8443-40a3-8229-f23196e9e06d IPADDR=192.168.11.200 NETMASK=255.255.255.0 GATEWAY=192.168.11.2 DNS1=192.168.11.2
将HWADDR修改为与ifconfig命令下相同的硬件地址
3、重启网络
[root@master ~]# service network restart
Shutting down loopback interface: [ OK ] Bringing up loopback interface: [ OK ] Bringing up interface eth0: Active connection state: activating Active connection path: /org/freedesktop/NetworkManager/ActiveConnection/2 state: activated
Connection activated [ OK ]
问题解决!