Linux 命令行运行Cisco Anyconnect
Linux 命令行运行Cisco Anyconnect
marsggbo
发布于 2022-06-14 16:13:43
发布于 2022-06-14 16:13:43
运行v**
/opt/cisco/anyconnect/bin/vpn连接
connect 你的IP地址例如
connect nhvpn30.vpn.nvidia.com完整示例
$ /opt/cisco/anyconnect/bin/vpn
Cisco AnyConnect Secure Mobility Client (version 4.10.05095) .
Copyright (c) 2004 - 2022 Cisco Systems, Inc. All Rights Reserved.
>> state: Disconnected
>> state: Disconnected
>> Network error. Unable to lookup host names.
>> Limited Access - DNS Failure
>> registered with local VPN subsystem.
VPN> connect ngvpn30.vpn.nvidia.com
connect ngvpn30.vpn.nvidia.com
>> contacting host (ngvpn30.vpn.nvidia.com) for login information...
>> notice: Contacting ngvpn30.vpn.nvidia.com.
>> Connection Banner
>> ***ATTENTION***
New way to Authenticate using DUO:
Type your password as follows: <Password><comma><DuoPasscode>
The DuoPasscode is good for one use, you will have to refresh in your duo app to get new DuoPasscode
For further instructions visit: https://nvidiaprod.service-now.com/sp?id=kb_article_view&sysparm_article=KB0020548
0) Employee
1) Employee_China
2) NV-Contractor
3) PSG
Group: [NV-Contractor] 2
Username: [test]
Password:
>> state: Connecting
>> notice: Establishing VPN session...
The AnyConnect Downloader is analyzing this computer. Please wait...
Initializing the AnyConnect Downloader...
The AnyConnect Downloader is performing update checks...
>> notice: The AnyConnect Downloader is performing update checks...
>> notice: Checking for profile updates...
>> notice: Downloading AnyConnect VPN Profile - 100%本文参与 腾讯云自媒体分享计划，分享自作者个人站点/博客。
原始发表：2022-06-13，如有侵权请联系 cloudcommunity@tencent.com 删除
评论
登录后参与评论
推荐阅读