[WSL][ubuntu][原创]windows上ssh WSL的linux子系统

登录后安装

sudo apt install openssh-client openssh-server

修改配置：sudo vi /etc/ssh/ssh_config

#   GSSAPIKeyExchange no #   GSSAPITrustDNS no #   BatchMode no #   CheckHostIP yes     AddressFamily any #   ConnectTimeout 0 #   StrictHostKeyChecking ask #   IdentityFile ~/.ssh/id_rsa #   IdentityFile ~/.ssh/id_dsa #   IdentityFile ~/.ssh/id_ecdsa #   IdentityFile ~/.ssh/id_ed25519     Port 22     ListenAddress 0.0.0.0     PermitRootLogin no     PasswordAuthentication yes #   Protocol 2 #   Ciphers aes128-ctr,aes192-ctr,aes256-ctr,aes128-cbc,3des-cbc #   MACs hmac-md5,hmac-sha1,umac-64@openssh.com #   EscapeChar ~ #   Tunnel no #   TunnelDevice any:any #   PermitLocalCommand no #   VisualHostKey no #   ProxyCommand ssh -q -W %h:%p gateway.example.com #   RekeyLimit 1G 1h     SendEnv LANG LC_*     HashKnownHosts yes     GSSAPIAuthentication yes

重启ssh服务：

sudo service ssh restart

查看自己的ip地址：

ifconfig

fut@DESKTOP-19QNH4E:~$ ifconfig eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500         inet 172.21.7.62  netmask 255.255.240.0  broadcast 172.21.15.255         inet6 fe80::215:5dff:fef7:b154  prefixlen 64  scopeid 0x20<link>         ether 00:15:5d:f7:b1:54  txqueuelen 1000  (Ethernet)         RX packets 48378  bytes 72720775 (72.7 MB)         RX errors 0  dropped 0  overruns 0  frame 0         TX packets 9399  bytes 875394 (875.3 KB)         TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536         inet 127.0.0.1  netmask 255.0.0.0         inet6 ::1  prefixlen 128  scopeid 0x10<host>         loop  txqueuelen 1000  (Local Loopback)         RX packets 32  bytes 4926 (4.9 KB)         RX errors 0  dropped 0  overruns 0  frame 0         TX packets 32  bytes 4926 (4.9 KB)         TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

登录：

ssh fut@172.21.7.62

注意端口22需要加入入站规则

配置Windows防火墙

打开windows Definder的高级设置:

• 点击左侧“入站规则”
• 点击右侧“新建规则”
• 选择“端口”
• 选择"TCP"
• 选择“特定本地端口”，并设定值为2222（与之前配置端口映射时的本机端口一致即可）