我正在尝试从我的wifi网络上的arp -a扫描中显示的设备中查找MAC地址。在MAC终端中调用"arp -a“的结果如何获取Mac地址?
? (10.10.40.1) at 0:90:b:2e:bf:ff on en0 ifscope [ethernet]
us114-appletv.francisparker.org (10.10.40.92) at 0:90:b:2e:bf:ff on en0 ifscope [ethernet]
03089mac.francisparker.org (10.10.40.236) at 0:90:b:2e:bf:ff on en0 ifscope
当我尝试使用ping命令时,当我在wireshark first ARP request中看到它时,在应答之后,只有ICMP请求正在运行,
我想这就是ARP第一次请求的原因,
在尝试ping时,需要知道目标设备的 MAC 地址,因此它首先尝试获取MAC地址,然后再发送ICMP请求。
如果是这样的话,那么可以在ping命令中提到mac地址(不要尝试使用ARP)。
如果这不是真的,原因是什么
%Apr 30 11:32:06:216 2000 ICT ARP/4/RATELIMIT: The ARP packet rate(178pps) exceeded the rate limit(50pps) on interface GigabitEthernet1/0/24 in the last 60 seconds.
%Apr 30 11:33:06:824 2000 ICT ARP/4/RATELIMIT: The ARP packet rate(170pps) exceeded the rate limit(50pps) on interface GigabitEthernet1
在CentOS6.5上,我有一个连接到eth4的桥接网络,运行在vnet0上的虚拟机(Centos6.5)也连接到那个接口(Vnet0)
bridge name bridge id STP enabled interfaces
network 8000.588d090ee15e no eth4
vnet0
VM的IP地址为10.99.9.10,eth2上的ip地址为10.99.9.2。