我想按照这些指示为我的Linux设置一个AP,但是这个设备不会出现在iw addr命令中
$ iw addr
nl80211 not found.
$ iw list
nl80211 not found.
$ ip link
1: lo: mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eno1: mtu 1500 qdisc fq_codel state UP m
我已经使用以下方法建立了一个监视器界面:
iw dev wlan0 interface add mon0 type monitor
ifconfig mon0 up
我正在使用libpcap捕捉和检查802.11帧和无线电抽头。我以前使用过以下Linux内核:
Linux armada 3.10.103-marvell armv7l GNU/Linux
我现在使用:
Linux armada 4.13.4-mvebu 2017 armv7l GNU/Linux
在使用旧内核时,我能够监视在wlan0接口上发送的所有RX和TX数据包。但是在新内核上,只看到RX数据包。我发现在运行tcpdump
/rtlwifi_new# make && make install
make -C /lib/modules/4.12.0-kali2-amd64/build M=/root/rtlwifi_new modules
make[1]: *** /lib/modules/4.12.0-kali2-amd64/build: No such file or directory. Stop.
Makefile:58: recipe for target 'all' failed
make: *** [all] Error 2
我试图使用以下命令来增强我的WiFi的链接
我有一个运行14.04的虚拟服务器,由hosted托管。我想使用snap安装Nextcloud。但是,安装snapd失败:
$ sudo apt install snapd
Reading package lists... Done
Building dependency tree
Reading state information... Done
The following extra packages will be installed:
cgroup-lite crda dmsetup grub-common grub-gfxpayload-lists grub-pc
grub-
man iwconfig声明:
power Used to manipulate power management scheme parameters and mode.
To set the period between wake ups, enter period `value'. [...]
Examples :
iwconfig eth0 power period 2
iwconfig eth0 power 500m unicast
iwco
我刚跑了:
sudo apt-get update && sudo apt-get dist-upgrade
这是我从第二个命令中得到的输出:
Reading package lists... Done
Building dependency tree
Reading state information... Done
Calculating upgrade... Done
The following NEW packages will be installed
linux-headers-4.4.0-38 linux-headers-4.4.0-38-gen
当我运行sudo apt-get dist-upgrade时,它会在最后输出以下内容:
The following packages were automatically installed and are no longer required:
linux-headers-4.2.0-16 linux-headers-4.2.0-16-generic
linux-image-4.2.0-16-generic linux-image-extra-4.2.0-16-generic
Use 'apt-get autoremove' to remove them.
我能自动移
我正在使用Ubuntu18.04并尝试使用apt卸载旧的内核映像。但是,我收到一个错误,它不能被卸载,因为标题丢失了。我如何卸载它们?下面是命令sudo apt autoremove的部分输出
Reading package lists... Done
Building dependency tree
Reading state information... Done
The following packages will be REMOVED:
linux-image-extra-3.13.0-39-generic linux-image-extra-3.13.0-40-gen
我正在使用buildroot来构建linux固件。我怎样才能只重新构建linux内核(而不需要构建一个小时的整个程序)?
我试过-
make linux-rebuild
但那可不是干净的。
我也试过
make linux-reconfigure && make linux-rebuild
但这也不起作用。
当我打开没有外部卡连接的笔记本电脑的内部有开发名称wlan0,然后我连接外部无线网卡,它是wlan1,我喜欢它。
但如果我将启动笔记本电脑与外部卡连接,它将是wlan0和内部成为wlan1。
问题是,我希望外部卡始终关闭电源安全模式,因此需要在启动时运行命令,如下所示:
iw dev wlan1 set power_save off
但是设备名称不一致,有办法解决吗?
apt-get install linux-headers-`uname -r`
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Unable to locate package linux-headers-4.9.0-kali3-amd64
E: Couldn't find any package by glob 'linux-headers-4.9.0-kali3-amd64'
E: Couldn't find any pa
我试图在Ubuntu14.04上安装3.16内核。我按照http://askubuntu.com/questions/506956/how-can-i-install-3-16-kernel-on-ubuntu-14-04的指令安装内核。我发现了这些错误:
Setting up linux-image-3.16.0-031600-lowlatency (3.16.0-031600.201408031935) ...
Running depmod.
update-initramfs: deferring update (hook will be called later)
The link /i
当我最近运行它的时候,它给我看了这个
~$ sudo apt autoremove
Reading package lists... Done
Building dependency tree... Done
Reading state information... Done
The following packages will be REMOVED:
linux-headers-5.15.0-46 linux-headers-5.15.0-46-generic linux-image-5.15.0-46-generic linux-modules-5.15.0-46-generic l